Diode-led DMX Wireless Transmitter/Reciever Manual de usuario descargar pdf (Pagina 2)

1.877.817.6028

www.DiodeLED.com

INSTALLATION GUIDE

[email protected] www.DiodeLED.com

2 OF 3

DMX WIRELESS TRANSMITTER / RECEIVER

Visit the on-line product page at www.DiodeLED.com for addional product specicaons & warranty informaon.

• DMX WIRELESS TRANSMITTER / RECEIVER Specicaon Sheet

For full specicaons.

Additional Resources

Transmier / Receiver LED Indicator Guide

Stac Color Device is not transming/receiving a signal

Blinking Red Device is transming signal

Blinking Green

Device is receiving signal

Operation

Troubleshooting

To set the wireless network ID, use a thin screwdriver or stylus and press

the buon recessed in the transmier. Up to 7 separate simultaneous

wireless networks may be set per locaon. Each ID is individually color-

coded (red, green, yellow, blue, purple, cyan, white). To set the ID:

• Press the buon once to display the current network ID color.

• Connue pressing the buon to cycle through the dierent networks.

LED indicator

for wireless ID

Recessed wireless

ID selector

90°

360°

Male

Female

5VDC

Input

5VDC

Input

Both male/female devices may be installed as a transmier and/or receiver.

LED xture responding incorrectly

Ensure all wiring connecons are correct. Reversing the Data + and Data - will cause lights to malfuncon or respond incorrectly to the controller.

1. Power connecons of all components (drivers, DMX decoders/xtures, DMX controller).

2. DMX controller data connecons - See DMX controller installaon guide.

3. DMX decoder PWM output connecons – See DMX decoder installaon guide.

Transmier / receiver(s) not pairing.

Ensure wall washers and/or DMX decoders are addressed to the proper ID. See ‘System Diagram’ for addressing wall washer / DMX decoder installaons

ulizing the on-board controls of a master wall washer. Installaons ulizing a remote DMX controller require specic addressing to match the zone

capabilies of the controller. See the DMX controller installaon guide for addressing informaon.

If sll not pairing, see Step 5 of ‘Installaon’ to perform a ‘so reset.’

1 2 3

1.877.817.6028 1
QUESTIONS? 3

Comentarios a estos manuales

Sin comentarios

Diode-led DMX Wireless Transmitter/Reciever Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Encendiendo Diode-led DMX Wireless Transmitter/Reciever