1 of 2
INSTALLATION GUIDE
K-RANGE 24™ WALL MOUNT CONTROLLER
IG022614-1.0
Safety & Warnings
Before you begin, read all warnings and installaon instrucons thoroughly.
Prior to installaon, verify all components are a compable system. Congure and pre-test your LED system prior to permanent installaon to ensure all
components are operang correctly. Install in accordance with the NEC and local regulaons.
• Install in accordance with the Naonal Electric Code, and local regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• Do not connect directly to high voltage 120V~277V power. Install with a
compable Class 2 constant voltage LED driver (power supply).
• Only install compable LED drivers and xtures. Contact technical support
or visit the product page for compable products.
• This product is rated for indoor installaon and is not protected against
moisture.
• Proper heat dissipaon will prolong the working lifespan of this product.
Install in a well-venlated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, xture, and any controls
in between. When choosing wire, factor in voltage drop, amperage
rang, and type (in-wall rated, wet locaon rated, etc.). Inadequate wire
installaon could overhead wires, and cause a re.
• Do not modify or disassemble this product beyond instrucons or the
warranty will be void.
Input / Output Voltage 12-24VDC constant voltage
Control Type
PWM (Pulse Width Modulaon).
Compable with 2-channel K-RANGE
xtures. Not compable with 3-channel
K-RANGE xtures.
Max Current Load 4A x 2CH
Max Output Power
96W/192W (12V/24V)
Ambient Temperature
† -4° ~ 122°F (-20° ~ 50°C)
Environment Indoor / dry locaon
For full specicaons, see the ‘Specicaon Sheet’ available at the online
product page.
Installation
Quick Specs
†
Do not install product in an environment outside the listed ambient
temperature. Ensure adequate airow and heatsinking is considered
when mounng/installing.
1. Turn OFF 120-277VAC power at circuit breaker.
2. Determine an accessible locaon to install a 12-24VDC constant voltage driver (driver voltage must match xture voltage). Do not install more than one
PWM controller can be aached to a single output of the driver.
3. Pull main power cable through switch box.
a) Aach low voltage load to K-RANGE controller.
b) Aach LED driver to K-RANGE controller. See ‘Wiring Connecons’ and Mounng.’
4. Wire LED driver to 120-277VAC power.
5. Pop o K-RANGE faceplate with a athead screwdriver and aach to switch box. See ‘Mounng.’ Do not remove ribbon cable from controller.
6. Ensure all connecons are secure and turn ON 120-277VAC power at circuit breaker.
WARNING
Shock Hazard. May result in serious injury or death.
Turn o power at circuit breaker before installing this product.
Ensure applicable wire is installed between driver, xture, and any controls in between. When choosing wire, factor in voltage drop, amperage rang, and
type (in-wall rated, wet locaon rated, etc.). Inadequate wire installaon could overhead wires, and cause a re.
(7 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales