Diode-led Solid Color Tape Light Manual de usuario descargar pdf (Pagina 3)

1.877.817.6028

www.DiodeLED.com

INSTALLATION GUIDE

3 OF 6

SOLID COLOR LED TAPE LIGHT

IG082514-2.4

Cut points not drawn to scale

CLICKTIGHT

™

Connectors

Close the CLICKTIGHT™ latch to ensure connecon.

When ready for mounng, peel o the 3M™ adhesive backing

of the tape and tear o along the connector tray edge. Mount

tape light and ulize a wiring harness to secure lead wires.

Open the CLICKTIGHT™ latch and note the +/- polarity markings.

Firmly insert the tape light into the connector tray with the

3M™ adhesive backing sll intact to the tape. Ensure the

contact/solder points of the tape are directly underneath the

metal placement tabs of the connector.

Wiring Harness 3M™ Adhesive

Aaching CLICKTIGHT™ Connectors

–

Cung Tape Light

Cung tape light densies lower than 2.88W/.:

Cut the tape at the cut line indicated with the scissors icon.

Ulizing CLICKTIGHT™ connectors requires specic cung instrucons for high density solid color tape light to achieve a proper connecon. See

opons A or B (does not apply to RGB tape light). Never cut tape aached to a live circuit. DO NOT solder CLICKTIGHT™ connectors to tape light.

Cung tape light densies higher than 2.88W/.:

DO NOT cut at the scissors icon. Instead, cut the tape along the outside

edge of the LED chip closest to the scissors icon so four contact/solder

points remain intact to the tape. This will ensure the latch of the

CLICKTIGHT™ connector closes properly.



–

Tape less than 2.88W/.

Tape 2.88W/. and higher

–

––

1 2 3 4 5 6

Sin comentarios

Diode-led Solid Color Tape Light Manual de usuario Pagina 3